FC - Forshield Topcoat & Sealer (ENG)
How to choose the Forcrete topcoat, ForShield 2K WB, Ultra, FX or PA, and roll it evenly without streaks.
Forcrete — Forshield Topcoats & Sealers
Overview and guide for final sealing with Forshield 2KWB, Ultra, FX, and PA.
• Forshield 2KWB: The standard topcoat for walls and most residential environments. Satin-matt finish.
• Forshield Ultra: A more durable and scratch-resistant lacquer designed for commercial areas and worktops where chemical resistance requirements are higher (identical sheen to 2KWB, but higher specification).
• Forshield FX: Ready-mixed pore filler providing a smoother and calmer finish, which also acts as the primary protective layer on Microgranite/Microstone outside wetrooms.
• Forshield PA: Polyaspartic sealer for heavy-duty floors, and as a primer coat (with thickening powder) on Microgranite/Microstone inside bathrooms and wet areas.
• Forshield 2KWB: 50 g/m² (42 g Component A + 9 g Component B).
• Forshield Ultra: 50 g/m² (42 g Component A + 8 g Component B).
Always calculate volumes and potential water dilution within the mixing app.
Preparation Before Starting
• Sanding: Sand the surface to your desired finish. Avoid leaving floor textures too coarse, as rough surfaces gather dirt and become difficult to maintain.
• Vacuuming & Wiping: Vacuum and dry-mop the substrate meticulously. Tack-wipe the entire area with a clean, dry microfiber cloth. Residual sanding dust compromises adhesion, and on dark shades, trapped dust creates white, patchy discolouration under the sealer.
• Temperature: All sealers must be at normal room temperature during application. Forshield Ultra must never be applied cold — place the container in a warm water bath to bring it to +25–30 °C before mixing to ensure optimal leveling and flow.
System Selection & Products
Our primary choice for residential walls and floors. Two-component polyurethane sealer engineered for durable daily protection.
Instructions: Forshield 2KWB ↗A harder, highly chemical-resistant coating designed for worktops, dining tables, and high-traffic commercial floors. Matches the exact sheen profile of 2KWB with upgraded mechanical strength.
Instructions: Forshield Ultra ↗Single-component system skimmed tightly using a rubber or plastic squeegee. Closes surface micropores to create a calmer, more refined aggregate texture. Replaces the first coat of 2KWB/Ultra, and serves as the mandatory base sealer on Microstone/Microgranite in dry areas.
Instructions: Forshield FX ↗Two-component polyaspartic offering exceptional mechanical resistance. Specified on smooth floorings needing maximum defense, or blended with 4% thickening powder as the initial pore-filling primer on Microstone/Microgranite in bathrooms and wet zones.
Instructions: Forshield PA Clear ↗Rolling Technique & Instructions (2KWB & Ultra)
Always use an 8 mm short-pile lint-free roller. Maintain consistent material delivery — dry rolling leaves patchy, striped lap marks.
• Pressure & Distribution: Roll side to side with firm, even pressure to wet out and saturate the microcement.
• Cross-Rolling: Immediately cross-roll the same section perpendicularly under moderate pressure.
• Lay-off: Lightly tip-off without downward pressure in a single, unified direction to eliminate roller stipple.
• Maintain Wet Edge: Work quickly into the wet perimeter boundary to blend seams wet-in-wet.
• Maintain continuous ventilation throughout installation and curing phases.
• Prevent skin and eye contact. Store above freezing temperatures and keep securely out of reach of children.
How did we do?
FC - Mixing and Pigmentation (ENG)