Skip to main content

TT - Application on Vinyl (ENG)

Preparing vinyl flooring in bathrooms before Topciment: priming seams, filling, drain grate and straight inside corners.

tomas martinsson
Updated by tomas martinsson
Guide / Preparation

Substrate Preparation: Application on Vinyl Sheet Flooring

Instructions for preparation, leveling transitions, floor drains, and application over existing vinyl sheet membranes.

🛑 Before commencing the project:
• Substrate Preparation & Cleanliness: Ensure the surface is sound, dry, and thoroughly cleared of contaminants and grease.
• Working Temperature: Ambient and substrate temperatures must be maintained between +10 °C and +25 °C throughout the installation.
• Condition of the Vinyl: Inspect the vinyl membrane thoroughly for damage, tears, or blisters. Check carefully around the floor drain and ensure wall upstands in corners are securely bonded without hollow voids.
• Substrate Rigidity: Soft, cushioned vinyl flooring is not recommended because substrate stability dictates the final outcome, and softer underlays substantially increase the risk of pressure dents from concentrated loads.

1. Preparation and Leveling Transitions

Textured Adhesion Primer (Ardex P4)

Prime vinyl sheet overlaps and coved upstands with an adhesion promoter for non-porous substrates (Ardex P4 is recommended) to create a mechanical key prior to leveling.

Leveling Seams & Upstands

Smooth out transitions and reduce coved angles at the upstands using a cementitious repair mortar (e.g., Ardex A46) or a moisture-resistant rapid tile adhesive. The goal is to flush out lap joints and square up the perimeter angles as cleanly as possible prior to microcement installation.

2. Floor Drain Grate Installation

Grate Selection & Bonding

Install a new metal drain grate (such as a low-profile microcement grate with approx. 3–4 mm rim height). Bond the grate in place using an approved waterproof hybrid adhesive (e.g., Tec7).

Leveling Around the Gulley

Feather out tile adhesive flush with the outer rim profile of the grate frame before applying microcement.

Full-Floor Scratch Skim

If floor slopes are subtle, building up a localized mound around the gulley risks compromising falls; in such cases, prime and skim coat the entire floor plane. Furthermore, partial patching with cementitious mortars introduces uneven porosity, whereas a full skim ensures uniform absorption.

3. Internal Corner Technique

Masking and Alternating Walls (Final Coat)

Where vinyl sheet lines both floors and walls, the internal transitions retain a slight curve. To create a crisp, rectilinear sightline on the final coat, tape a straight line into the junction against adjoining walls that are held back. Once the coated walls are dry, denib them lightly, mask off the newly finished faces, and trowel the remaining two walls.

4. Next Steps: Primers & Build-up

How did we do?

TT - Application on Waterproofing Membranes (ENG)