Skip to main content

TT - Acricem Resin (ENG)

Acrylic resin used as a primer on absorbent substrates and as the mixing liquid (component B) for Topciment microcement.

tomas martinsson
Updated by tomas martinsson
Product Guide / Resins & Liquids

Topciment — Acricem Resin

Acrylic resin for regulating absorbency on porous substrates and serving as the liquid component (Component B) for two-component microcement.

🛑 Before You Begin:
• Substrate & Cleanliness: Ensure the surface is sound, dry, and free of dirt, oil, and grease.
• Substrate Must Be Level: Microcement is applied in very thin coats and will not conceal underlying depressions, hollows, or height discrepancies.
• Working Temperature: Ambient room and substrate temperatures must remain between +10 °C and +25 °C throughout.
• Reinforcement Mesh: Fiberglass mesh must always be installed before troweling the first base coat.

1. Application Areas

As a Primer on Absorbent Substrates Primer

Saturates porous substrates such as concrete, self-leveling screed, and tile adhesive prior to troweling microcement.

• Application: Apply 1 uniform, fully covering coat by roller or brush.
• Drying Time: Allow at least 30 minutes for the surface to dry.
• Application Window: Apply the first coat of microcement within 24 hours of priming.
As Mixing Liquid (Component B) Mortar

Liquid resin mixed with microcement powder and color pigment.

1. Measure the specified volume of Acricem Resin into a clean bucket.
2. Add the pigment dose and stir thoroughly until completely homogeneous.
3. Gradually introduce the powder while paddle mixing at low speed for at least 4 minutes until lump-free.

2. Formulations and Mixing

Quantities and Proportions

The required volume of Acricem Resin depends on the specific microcement product and aggregate grain size being mixed. Always use the mixing app to calculate accurate proportions and project material requirements.

Documents and Technical Datasheets

📄 Technical Documentation: Acricem Resin
🛡️ Health & Safety Equipment & Tool Care:
• Protective Equipment: Wear protective gloves and safety goggles during all handling and mixing. Ensure adequate room ventilation.
• Cleaning: Clean tools, buckets, and rollers with water immediately after use before the resin dries. For dried material, clean tools using acetone or wipes.

How did we do?

TT - Microbase / Natture L (ENG)