Skip to main content

TT - Primacem ABS (ENG)

Ready-mixed primer for absorbent substrates before microcement.

tomas martinsson
Updated by tomas martinsson
Guide / Primer

Topciment — Primacem ABS

Instructions for priming absorbent substrates prior to troweling microcement.

🛑 Before You Begin:
• Substrate & Cleanliness: Ensure the surface is sound, dry, and free of dirt, oil, and grease.
• Substrate Must Be Level: Microcement is applied in very thin coats and will not conceal underlying imperfections or hollows.
• Working Temperature: Ambient room and substrate temperatures must remain between +10 °C and +25 °C throughout.
• Reinforcement Mesh: Fiberglass mesh must always be installed before troweling the first base coat.

1. Suitable Substrates

Absorbent Surfaces

Use Primacem ABS on porous substrates to saturate porosity and ensure optimal adhesion. The product is ready-mixed and can be applied straight from the container onto:
• Plaster and drywall/plasterboard
• MDF and other absorbent wood- or board-based materials
• Tile adhesive, self-leveling screed, and concrete

Alternative for Tile Adhesive, Screed, and Concrete

On concrete, self-leveling compounds, and cementitious mortars, both Primacem ABS and Acricem Resin serve as excellent primers.

2. Preparation & Application

Application

Apply the primer evenly with a roller or brush across the entire substrate without leaving dry spots. Apply in 1 uniform, fully covering coat.

Drying Time & Application Window

The primer is touch-dry after approximately 20–30 minutes at standard room temperature and ventilation (use a circulation fan if necessary). Allow at least 30 minutes before starting the next operation so the film can dry completely. Trowel the first base coat within 24 hours of priming.

Installing Fiberglass Mesh

Once Primacem ABS has dried, secure the fiberglass mesh to the absorbent substrate using Primacem Plus before embedding the mesh with the first base coat.

3. Next Steps: Reinforcement & Base Coat

Proceed to the reinforcement mesh guide or the base coat instructions:

Documents & Technical Datasheets

📄 Technical Documentation: Primacem ABS
🛡️ Health & Safety Equipment & Tool Care:
• Protective Equipment: Wear protective gloves and safety goggles during handling and application. Ensure adequate room ventilation.
• Tool Cleaning: Clean tools and rollers thoroughly with water immediately after use before the primer dries. For dried residue, clean tools using acetone or wipes.

How did we do?

TT - Presealer (ENG)

TT - Primacem Plus (ENG)