Skip to main content

TT - Mixing and Pigmentation (ENG)

How to calculate quantities and mix Acricem Resin, pigment and cement powder into a smooth, lump-free paste.

tomas martinsson
Updated by tomas martinsson
Guide / Preparation

Mixing: Resin, Cement & Pigment (Topciment)

Instructions for preparation, batch calculation, and step-by-step mixing.

🛑 Before commencing the project:
• Working Temperature: Ensure both the acrylic resin and cement powder are maintained between +10 °C and +25 °C before mixing begins.
• Material Temperature: Cold material makes the wet mix significantly stiffer to trowel and can impart an unwanted bluish hue to the cured finish.
• Bucket Selection: Do not use black builder buckets made of soft recycled plastic, as the paddle mixer can shave plastic flakes off the bucket walls. Use clean, rigid plastic buckets (white or translucent).

1. Batch Calculation & Adjustments

Calculate Material Quantities

Use our mixing app to calculate the exact ratios of Acricem Resin, cement powder, and pigment. Use 80% of the measured floor/wall area as your baseline input in the app (experienced applicators typically consume approx. 70–80% of standard theoretical coverage). Example: If mixing for 10 m², input 8 m² into the app.

Adjusting Resin Ratio (Viscosity)

Resin volumes can be tailored by approx. ±10% depending on desired trowel feel:
• For Floors: Add approx. 10% extra resin for a more fluid, easily workable mix.
• For Walls: The default formulation generated by the app performs optimally.
Note: Do not add more than 10% additional resin, as excessive liquid introduces air entrapment pinholes. Reducing resin by more than 5% significantly accelerates set time and shortens pot life.

2. Workflow: Step-by-Step Mixing

Step
Operation & Execution
Step 1
Weigh the resin: Measure and weigh out the specified amount of Acricem Resin into a clean bucket.
Step 2
Prepare the pigment: Shake the pigment bottle vigorously beforehand and open carefully. Close the cap immediately after dosing to prevent pigment skinning in the container. The selected topcoat sealer dictates the exact formulation and pigment dosing in the app.
Step 3
Add pigment: Dose pigment according to the recipe. Use precision scales on smaller mixes to maintain complete batch-to-batch color accuracy.
Step 4
Blend pigment and resin: Stir the pigment thoroughly into the liquid resin until fully dispersed into a uniform color before adding any cement powder.
Step 5
Add powder: Weigh out the microcement powder into a separate bucket and add it gradually into the liquid under mechanical mixing.
Step 6
Initial mix: Mix at low RPM for approx. 1 minute. Scrape the sides and bottom of the bucket thoroughly to ensure no dry, unmixed powder remains.
Step 7
Final mixing: Continue paddle mixing for at least 3 minutes until the compound is silky smooth and entirely lump-free.
Step 8
Slake / Rest period: Allow the wet mix to rest for approx. 5 minutes prior to application so entrained air from paddle mixing escapes to the surface.

How did we do?

DC - Titan Topsealer (ENG)

TT - Sanding Guide (ENG)