FC - Care and maintenance: public spaces (ENG)
How to look after Forcrete in shops, offices and other public spaces: cleaning routine, scrubber dryer, Ecoclean and Forcrete Renovator.
Care and maintenance / Public spaces
Forcrete in public spaces: care and maintenance
Surfaces with a lot of foot traffic need regular cleaning. Follow the advice below.
Curing
- The sealer cures to 80–90% in the first week and is fully cured after 14 days. Cold, damp and poorly ventilated rooms can extend this time. Take extra care with the surfaces while they cure.
- Do not use any cleaning products for the first 14 days. After that, use only pH-neutral cleaners.
- Do not cover the surface for the first 14 days. After 4–5 days you can cover it for an hour or so while you work, but then remove the cover to avoid discolouration.
Cleaning
- Clean a sealed surface regularly to prevent permanent stains.
- Do not use abrasive cleaners or strong chemical products, only pH-neutral cleaners. Contact us if you are unsure or want to buy our cleaning products.
- Never use cleaning products other than the ones we recommend. They can damage the surface and the sealer.
- Use a scrubber dryer on surfaces that get very dirty.
- For tougher stains we recommend Forcrete Stain Remover or Pinkstuff. Always test on a hidden area first. Stains that have not had time to set are easy to remove.
Cleaning routine
- Vacuum or mop as needed, preferably a few times a week. The more often, the easier dirt and stains come off.
- Mop or scrub the floor with Ecoclean at least twice a week, more often with heavy traffic. Mix 0.5–1 dl of Ecoclean in 10 litres of water, up to 2 dl if the floor is very dirty.
- Remove tougher stains with Pinkstuff, following the instructions on the tub.
Maintenance
- Use Forcrete Renovator on the sealer for better protection against scratches and stains and easier care. Mop or wipe it on with a microfibre cloth after cleaning the surface. Renovator leaves a thin protective film. How often depends on wear; count on about 3–4 times a year. Apply it after a thorough clean. Never use Renovator in bathrooms, saunas or outdoors.
- Never use a steam cleaner on sealed surfaces.
- Avoid contact with hair dye, bleach and other strong pigments.
- Avoid sharp objects and point loads. Always put felt pads under furniture.
Good to know
Microcement wears over time, just like other cement-based surfaces. Forcrete is among the most hard-wearing alternatives to concrete floors.
💬 Questions about cleaning and maintenance? Contact us at info@designcement.se.
How did we do?
FC - Care and maintenance: pools (ENG)
FC - Care and maintenance: saunas (ENG)