FC - Care and maintenance: bathrooms (ENG)
How to look after Forcrete in a bathroom: curing in the first weeks, cleaning, floor heating and what to avoid.
Care and maintenance / Bathroom
Forcrete in bathrooms: care and maintenance
Follow the advice below and the microcement in your bathroom will keep its properties.
Curing
- The sealer cures to 80–90% in the first week and is fully cured after 14 days. Cold, damp and poorly ventilated rooms can extend this time. Take extra care with the surfaces while they cure.
- Ideally the surface should not come into contact with water in the first week after the last coat of sealer. If that cannot be avoided, wait at least 3 days and be careful.
- Do not use any cleaning products for the first 14 days. After that, use only pH-neutral cleaners.
- Do not cover the surface for the first 14 days. After 4–5 days you can cover it for an hour or so while you work, but then remove the cover to avoid discolouration.
Cleaning
- Clean a sealed surface regularly to prevent permanent stains.
- Do not use abrasive cleaners or strong chemical products, only pH-neutral cleaners. Contact us if you are unsure or want to buy our cleaning products.
- For tougher stains we recommend Forcrete Stain Remover or Pinkstuff. Always test on a hidden area first.
Floor heating
- Floor heating must be switched off during application and for a few days afterwards. Then raise the temperature gradually, by no more than 3 degrees a day. The substrate underneath may need longer to dry than the microcement.
- Avoid large and sudden temperature changes in the floor heating so the cement does not crack.
Keep in mind
- Never use a steam cleaner on sealed surfaces.
- Avoid contact with hair dye, bleach and other strong pigments.
- Avoid sharp objects and point loads. Always put felt pads under furniture.
- Never use Forcrete Renovator in a bathroom.
💬 Questions about cleaning and maintenance? Contact us at info@designcement.se.
How did we do?
FC - Care and maintenance: countertops (ENG)